Listing

You may want to know the contents of a series of data registers or the status of the calculator. The LIST function provides you with this capability. You can also list programs and labels as explained in the RPD-95 Programming Guide. If you enable the printer, you can capture the printer listing. For more information, refer to chapter 6, "Using an Optional Printer".

Listing Data Registers

To list the contents of a series of data registers:
  1. Press [ LIST ]. The display shows the list options.D_YoeKBv
  2. Enter the address of the first register to list. If you do not enter an address, the list begins at register 000 each time you press the [ LIST ] key.
  3. Select { REG }.

Beginning with the specified register, the calculator lists the addresses and contents at a one-second rate.

If you do not have a printer enabled, you can use the [ → ] key to control the speed of the displayed listing.
  • To pause the listing indefinitely, hold down the [ → ] key.
  • To advance through the listing without the one-second pause, repeatedly press and release the [ → ] key.

Listing the Calculator Status

Press [ LIST ] { ST } to list the current calculator status.

The calculator lists the current partition settings and each parameter that is not currently set to its default setting. Parameters that are currently set to their default settings are not listed.

The list is displayed at a one-second rate. You can use the [ → ] key to control the speed of the listing.

If you have the printer enabled, the listing is also printed. For more information, refer to Chapter 6, "Using an Optional Printer".

The list below shows all possible statuses.
  • Partition (memory)
  • Angle Mode ( degrees, radians, grads )
  • Hexadecimal Mode ( with or without two's complement )
  • Octal Mode ( with or without two's complement )
  • Flags set ( flag numbers )
  • Fixed decimal ( places )
  • Module ( installed )
  • Word Break mode ( if turned on )
  • Print Device ( number )
  • Print Width ( number )
  • System Mode ( if selected )
  • Last Error ( since [ LIST ] { ST } function last used )

Stopping the Listing

To stop a listing before all register contents or status messages have been displayed, hold down the [ BREAK ] or [ HALT ] key until the word LIST: is displayed.

After you stop a listing, you can perform other operations or you can list registers again by selecting { REG }. The list beings at the number in the display register. If an alpha message is in the display, you can press [ CE ] to see the number.

☚ Back